Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Njinear

  1. Njinear

    Tolerance of Distance Between Shaft End (DBSE)

    CouplingGuru is spot on. Typically position the equipment a little bit more then the designed coupling BE, then slightly overhang the hub. This can be tricky if you have a taper bore and don't have that flexibility. But in scenarios with taper bores, most often the coupling manufacturer...
  2. Njinear

    Alignment Targets for Large TEFC Motors

    Wow, I kind of stumbled on to this thread, but there is a lot of great disc coupling information in here. CouplingGuru, you have certainly demonstrated your knowledge of couplings. I have never heard of PSC Couplings though. Thanks for the great discussion, I will have to save this one for...

Part and Inventory Search