Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Paul Hins

  1. Paul Hins

    Type of rubber recommendation

    PUD, That is probably a good thing that it does not reduce in volume. It would make a better seal I think as material bulges out.
  2. Paul Hins

    Type of rubber recommendation

    COMPOSITEPRO, I can make the mold fairly easily, but I am wondering if it would be better to simply laser cut it it out of EPDM. Although I am not sure if the laser would cut it clean or melt it. The gasket that I need to make fits inside a deep (approx 1" deep) grove and there is the...
  3. Paul Hins

    Type of rubber recommendation

    I am looking for a recommendation for the type of rubber to make a square profile O-ring that meets the following criteria 1)The O-ring will be subject to temperatures down to -45ish Celsius (-50ish Fahrenheit) and still remain flexible enough to apply the following pressure. 2)The O-ring will...
See more

Part and Inventory Search

Back
Top Bottom