Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Paul1342

  1. Paul1342

    Square to round ducting flat pattern with bend lines NX

    Hi 3DDave, thank you for the help, I have done that, the problem with that is that the bend lines don't originate from the corners
  2. Paul1342

    Square to round ducting flat pattern with bend lines NX

    Nveremind, when I mirror the half one, and make seam,it can be flat patterned.
  3. Paul1342

    Square to round ducting flat pattern with bend lines NX

    Hello everyone, I would like to make a square-to-round ducting and flat pattern it for laser cutting. The bend lines should originate from the square corners like the picture below done in Solidworks. - I have used the through curves method, but that method does not show the bend lines in the...
See more

Part and Inventory Search

Back
Top Bottom