Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by power1981

  1. P

    API 650 SPOT RT

    I have went through this RT Requirements but i am not sure if my interpretation is correct that we need to take RT on all T joints above 10mm (4th point in the notes below the figure)
  2. P

    API 650 SPOT RT

    Constructing a new tank acc. to API 650
  3. P

    API 650 SPOT RT

    For thickness between 10 to 25mm,if we have some shells between these ranges , Do we require 100% for Intersection or T-joints ?
See more

Part and Inventory Search

Back
Top Bottom