Recent content by Proizvodnja

Thanks for the tip.

Hi, I 'm trying to get reference point as result of intersection of plane and sketch that is perpendicular to the plane,but SW is not accepting.Any idea what is alternative?Thanks

How can I get reusable references in dialog?NX 1855 https://community.sw.siemens.com/s/question/0D54O00006UvtaiSAB/pattern-feature-reusable-references-which-is-which

Thanks

OK it's obvious it was done in several operations but in what sequence is the question

HI How is this sheet metal edges bended on this engine mount?

How to save part as a separate file from step assembly?

I tried different things, including the rest mill for a corner, and keep getting the error message "the part cannot be cut at any levels". Also, what does tool overhang mean?

How to remove in a planar mill these leftovers in corners. I used different machining strategies but they all result the same outcome regarding leftovers more or less.

@multicaduser Thanks for the effort, but I can't open the part it's from the newer version of NX.

Thanks for the suggestion, but I don't have this new version.

Is it possible to make configurations (like in SW) in one part but not as a family part? I want to use one part in CAM, make an operation and then just update on different dimension variants.

Thanks for the reply. How to set MOM_force_block condition?

In line 31 there is no output of the position of the circle center even though there is force output for CC in the post builder. 16 CC X150.438 Y-209.8 17 C X107.808 Y-202.802 DR- 18 L X108.07 Y-201.207 F250. 19 L X53.303 Y3.186 F250. 20 L X46.059 Y1.244 F250. 21 L X75.037 Y9.009 FMAX 22 L Z21...