I have a 40"x10"x125" that contains approx. 750 liters of water. the tank is open to air at the top, though completely protected from the wind.
Considering an outside temperature that can go as low as -30 Celcius in the winter, I need to keep it from freezing when the system is not in function...
I am trying to align holes in Solid Edge ST in a fast way - using up to V20 you would use the vertical/horizontal align tool to align them - but since the holes in ST are not sketch driven, that tool is not longer an option.
The solutions given to me by our SE supplier have been less than...
