Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Reisaku Quilay

  1. R

    316/316L Annealed and Cold Worked but still considered Condition A?

    I think I see it now. The ASTM spec did mention light cold drawing as a cold finishing operation for bars. I didn't think it could be done lightly enough to not have any measurable cold working.
  2. R

    316/316L Annealed and Cold Worked but still considered Condition A?

    I've been looking at a lot of MTRs that state annealed and cold worked 316/316L but still state compliance to condition A of ASTM standards (ASTM A276 and some others). Shouldn't it be condition S if it was annealed and then cold worked? Does the condition A statement make it so that they mean...
See more

Part and Inventory Search

Back
Top Bottom