Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

rickyt's latest activity

  • rickyt
    rickyt replied to the thread CATIA measure along direction.
    See if you have "Distance Analysis" command might not be available depending on which license you have. From top toolbar View>Command...
    • 250327-Image-003390.jpg
    • 250327-Image-003391.jpg
  • rickyt
    rickyt replied to the thread CATIA measure along direction.
    I would try the "Extremum Definition" under points. Generate one Extremum point on the curve in the Z Direction. Generate one Extremum...
    • 250324-Image-003368.jpg
  • rickyt
    rickyt replied to the thread Dimension representation......
    Looks like a foreshortened dimension due to the view being broken. The wire is much longer than what is shown in view, so the wire is...
  • rickyt
    rickyt replied to the thread CATIA v5 DRAFTING.
    Search Catia UUID to get a better understanding. If you made part 1 plus the .catdrawing. And then did a change to part 1, but when...
    • 250226-Image-003179.jpg
  • rickyt
    rickyt replied to the thread StartCommand ON/OFF instead of toggling.
    hadzill, what current state are you checking? For example below, Script checks the current state of z-buffer setting. In this case it...
Show older items

Part and Inventory Search

Back
Top Bottom