Recent content by rpedde01

Hey Sorry it was my mistake . I don't have any attachments. I was essentially looking for how to calculate area of a swirler of a combustion burner.

Can any one help me in calculating the area of a swirler, with 60degree angle and 16 fins with interanl diamieter of 347mm and outer diamter of Pipe is 694mm.

Hi, i am designing fuel control skids for the Diesel, Natural Gas, Heavy Fuel Oil and some of waste fuel oils. The pressure and temperature ratings are Diesel 150psi, 30°C. Gas 70psi, 30°C Heavy Fuel Oil 150psi, 200°C. I need some assistance in decided the right material in each stage of...

Thanks JMW for the suggestions. But we are one of Big companies and we have to standardise the fuel skids for cost and time reasons. I will eventually be sent out for fabrication to one of the manufacturers, but we would like to have our design. If we have standardized fuel skids from which we...

My flow requirements are 1000, 2000, 3000, 4000, 5000, 10000, 12500, 15000 kg/hr for desiel which varies from 5 to 75 GPM. so i would like to design the fuel skids for diesel, heavy fuel oil later to gases also. For liquid fuels the inlet pressures range from 145 to 150 psi and outlet...

Control skid is one which controls the fuel flow and fuel pressure. i want to standardize the skids because we have different flow requirements for different size of burners. any ideas?

Happy new year, I am working on a project to standardise the sizing of control skids for natural gas, diesel and heavy fuels oils. i am looking for ideas for easy way of doing this. seprating them by flow requirements? pressure requriemnts? any help is appreciated. thanks

Hi Pressure drop/unit length is the pressure that you loose when any fluid ( gas, fuel oils, water) flow trough a pipe. This information will be mainly used to acureately size the equipment upstream and down stream of pipes. upstream equipments could be compressors, pumps. Down stream...

Hey, i have a question for sizing the natural gas control skids and propane control skids. The project i am working on has a Propane control skin and propane burners. we have to work on the same burner to use for the Natural Gas. so what kind of factors i need to consider and how should i...