Ok Mate.
Let me see if Ive got this right.
Gas..
Nozzel dia sq x gas pressure x .555 = CM3 (cubic meters sq per hour)
Example:- 1.5mm dia nozzel SQ = 1.23 x 5 bar pressure x .555 = 3.41 CM3 hour.
My tank holds 240L Liquid oxygen which expands to 201,600L converted to cubic meters would be...
Do you have an example pls. For instance. If the nozzle is 1.5mm and the part needs 1 bar of pressure and it takes 60 sec to cut the part. What would I use. We pay .55p per litre for liquid oxygen it's a big vessel. Thanks
Foostrap ur information has been well received thankyou. The other parts I need to get my head around is the consumables. We cut a part for example say 2mm mild steel with oxygen it's a 50mm sq with four hold 10mm in dia. I know how long it would take from the software and I know the machine...
Hi guys,
My new Trumpf Laser 1030 has arrived today and Im looking for some advice on running costs. I would like to make a spreadsheet so I can cost parts up for quotations. We have Radan software so it gives me the cutting time to complete the job but I need more info for example.
I know the...
I had an alpha for 10 years and this problem occurred a few times. It was never the head that needed replacing. Some times by doing a calibration on the Hs-95 it sorted the problem. Make sure the setting on the side of the machine are 8.9, -8.9 and 0. If this fails you may need a new sensor cable.
Just an update guys. Delivery it to username two weeks. Very excited! Had some serious problems thou. When the engineer came to check where we wanted to put the machine we where told it won't fit because a column was in the way. So we have had to move around all the machine in the factory...
Really nice machine mate. No turbine so u don't have to worry about that and no end stage valve which has tobe changed every 5000 ish hours at a nice bend me over price of 6000. Only real cost is the bellows if u put holes in it and that will set u back 8 grand plus. All said I can't wait till I...
Hi mate. It has an automatic shuttle table on the front. So it ain't that hard. Using a fork lift carry the sheet U tilt the forks and lay the sheet down. You can buy an arm with suction pads and use that too. Or make ur own.
I'm getting a Trumpf 1030 now guys. Decided that if fits the bill. 100 plus thousand for a refurb machine that's 10 years old add another 100 thousand and u get a new 1030. At least I know what's I'm paying every month without surprises from old machines going wrong.
Why is the bean quality better? With an rf laser it either cut or it don't with a dc it will slowly cuts the material as the turbine needs overhauling . I saw prima today. Nice laser same turbine as Bystronic. You get alot of machine for the money. I really like the trumpf 3030 and 2530. But I...
I have looked at the fiber but it's to expensive and I know it's a super fast machine down the straight but most parts have corners and according to Bystronic it struggles going around them. We mainly cut 5mm mild steel anyway . What's the by sprint 2.2 like on 8 to 12mm mild steel? I just...
The LVD is a Hybrid machine and thats not what I want. I’m looking for a shuttle table so the Amada alpha 4 is a no now. Went to see Bystronic yesterday and looked at the Bysprint and Byspeed great machines but very expensive. My worry is our workload at the moment. We have enough work to run...
