Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by s_saranya

  1. s_saranya

    Yield line theory for concentrated load and modelling

    The purpose of SDOF system is to simulate a machine. And to study its behaviour under dynamic analysis. I am doing in SAP 2000
  2. s_saranya

    Yield line theory for concentrated load and modelling

    Hi, 1) I need to distribute a concentrated load to the beams as Uniformly Distributed Load(UDL) using Yield line theory, which is acting at the centre of slab. Slabs (two way) are not modelled, but the the slab weight is transferred to beam as UDL. 2) If the slabs are not modelled, how to...
  3. s_saranya

    Length of Plastic Hinge in steel sections

    Hi, Can anyone tell or give reference to find length of plastic hinge in steel sections for beams and columns? For example in RC sections, it is approximately 0.5 times of depth of the section.
  4. s_saranya

    Regarding CDP model

    I have modelled concrete with a yield strength of 20 Mpa for a sub-assemblage model. But, from dynamic analysis, the Von mises stress distribution shows a maximum stress of around 60 MPa. What is the reason?
  5. s_saranya

    Regarding DAMAGET variable

    Thank you, Hello, one more doubt.. for cyclic loading we should check PEEQ or PEMAG? what is the difference? I can see PEEQ has higher strain than PEMAG.
  6. s_saranya

    Regarding DAMAGET variable

    Hello all, I have used concrete damaged plasticity model in concrete. I can see the damage distribution pattern in DAMAGET variable. I want to relate the DAMAGET variable with the tensile stress of concrete? Which stress parameter should I choose only to see the tensile stress of concrete? I...
  7. s_saranya

    Cohesive interaction zone parameters

    These papers discuss about the steel concrete interface
  8. s_saranya

    Cohesive interaction zone parameters

    Hi all, I am assigning Cohesive zone surface interaction parameters as mentioned below in interaction module between bolt and concrete surface. Knn, Kss, Ktt, Normal only, Shear-1 only, Shear-2 only, damage evolution parameter. As far as I searched in the literature, in each paper different...
  9. s_saranya

    Regarding Gravity load

    The error got resolved. Thank you
  10. s_saranya

    Regarding Gravity load

    Do you know how to apply forced displacement on ABAQUS?
  11. s_saranya

    Regarding Gravity load

    Yeah did that. Then also it is not converging
  12. s_saranya

    Regarding Gravity load

    Hi, In the following figure, I have used spring elements in between the base plates to connect. When I apply gravity load, the results are not converging. But without spring elements, the gravity analysis is converging. I need to include spring elements in the gravity analysis. Can anyone tell...
  13. s_saranya

    Pretensioning anchor bolts

    Hi dold, 0.8Fy as suggested from literatures. I am simulating a shake table testing experiment in ABAQUS model and validating it. So it is necessary .
  14. s_saranya

    Pretensioning anchor bolts

    Thank you, I am validating ABAQUS model with experimental results. So the dimensions are already fixed. for i) , iii) and iv) Can you suggest any standard reference books?

Part and Inventory Search