Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by saitools

  1. saitools

    Latest in floating roof tank seals

    would like to know the latest trends in floating roof tank seals for VOC emission control Thanks Rajan
  2. saitools

    Thickness of accumulator bladders

    Would like to know the thickness of accumulator bladders of 50 liters or any capacity Thanks Rajan
  3. saitools

    Accumulator bladder design

    Would like to know the basis for designing an accumulator bladder thickness for working pressure 6 bar in Naphtha service.thanks Rajan
  4. saitools

    allowable stress in tension for Vton A

    BLN, You have been most helpful! Million thanks. Best regards, Rajan
  5. saitools

    allowable stress in tension for Vton A

    My understanding is rubber does not have an yield point/it is not reported in standard specs.Can we safely use 1/3 of UTS which is a guaranteed value as Minimum UTS by all rubber manufacturers? Please advice Thanks a million Best regards Rajan
  6. saitools

    allowable stress in tension for Vton A

    The designer can design the component only on the basis of the allowable stress for the material.The working stress will be much lower than the yield/max stress .I want to know the safety factor on yield/ Ultimate tensile stress. All temperatures are ambient. Thanks Rajan
  7. saitools

    allowable stress in tension for Vton A

    I would like to know the allowable stress in tension for Viton A rubber expressed either as Pounds per square inch or elongation %. Thanks Saitools
See more

Part and Inventory Search

Back
Top Bottom