Recent content by Sdk444

Thanks everyone. I'm searched the internet long and hard and have found nothing. I'll look to contact hydrology studio, thanks LincolnPE.

Thanks, that's very unfortunate. We are a very small firm and we had one rather old computer with 2007 hydraflow that recently crashed. We can use our hydrocad 10 however we will certainly need to access old hydraflow files at some point.

Hello, Does anyone know where/if I can buy any version of Hydraflow Hydrograph anyway. It seems to be discontinued but I'm shocked that I can't even find used versions. Thanks in advance.

Never mind. I've found what I was looking for. Very simple.

Hello All, I use hydraflow (2007) for most all stormwater management needs. For my current project I wanted to print the hydrographs and the routing in a table format instead of as illustrated graphs. Can't seem to find the setting to change this in the report printout. Any help is much...

Hello all, I'm relatively new to HydroCAD I've been working significantly more with Hydraflow. I have a subcathment that needs to be reduced for the 2, 10 and 100 year storm events. If I create a link I can apply one discharge multiplier. But how do I apply several multipliers to the same...

Thanks so much for your response. I've gotten the encroachments to show up. As I mentioned in my first post I'm looking to see what the floodway would be with a 0.2 foot rise in water elevation. This should be the value (+0.2) I'm looking for in the Delta WS column of the Standard Encroachment 1...

I got it to see the profile I wanted but now I can't seem to get any results coming through. I don't know what I'm doing wrong. I see others have posted about going to each cross section individually? I'm not sure what this means. If I'm not mistaken I'm supposed to see thick black lines on the...

Hello all, I'm working with Hec-Ras to perform a floodway encroachment analysis. I've followed the simple directions in the help manual. I've accessed the encroachment window via steady flow analysis. Once the window is open I have my offsets set to zero and I have it checked to do equal...

Thanks for your response. I see now I can use the Link icon to create a manual hydrograph. But like I could do in Hydraflow, isn't there a similar window where I can input my target flows to have the program give me SDF's? I use these SDF's to mutliply my Tc by to direct me to use the proper...

Hello, I'm trying to adjust to HydroCAD coming from Hydraflow Hydrographs. I'm having difficulty setting up a modified rational method hydrograph. The entire owner's manual has about one sentence on it regarding rise/fall factors. So I went to calculation settings> choose rational method>...