Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Selene716

  1. Selene716

    Ejector Pin Height

    I'm sorry for the confusion. It should say "the ejector pin marks on the part range from .001 below...." The ejector pins themselves are in the mold, not in the part.
  2. Selene716

    Ejector Pin Height

    I have a call out that states "Ejector pin marks permissible on surf E up to .010 max depth." Now, the ejector pins on the part are range from .001 below the surface to .002 above it. Since it doesn't specifically say flush to .010 below, do I then follow the surface profile as a tolerance?
See more

Part and Inventory Search

Back
Top Bottom