Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SPDL310's latest activity

  • SPDL310
    SPDL310 replied to the thread Control Valve CFD Analysis.
    I have used pressure inlet/outlet configuration to get Cv values for valves that have been tested. I generally try to allow my modeled...
  • SPDL310
    SPDL310 replied to the thread Control Valve CFD Analysis.
    This is question best posed in the CFD forum. You will be fighting convergence with the pressure inlet/pressure outlet configuration...
  • SPDL310
    SPDL310 replied to the thread Axial Control Valve Sizing.
    The 10,000 sm3/h figure seems more reasonable for a low flow scenario, and if that is the case your valve might not be over sized. The...
  • SPDL310
    SPDL310 replied to the thread Axial Control Valve Sizing.
    The information you have is not appropriate for sizing a valve as LittleInch has already stated. The customer normally fills out a...
  • SPDL310
    SPDL310 replied to the thread Steam Application Valve Stem Material.
    At over 1000°F you are probably getting into the creep range of 17-4 and are losing nearly half of your original yield strength. You...
  • SPDL310
    SPDL310 replied to the thread Natural Gas Cavitation.
    Please see the following on natural gas behavior. https://petrowiki.spe.org/Natural_gas_properties To fully asses the risks to the...
  • SPDL310
    SPDL310 replied to the thread Natural Gas Cavitation.
    If your process modeling shows that your natural gas is 100% gas at the inlet conditions then there can be no cavitation. You are...
Show older items

Part and Inventory Search

Back
Top Bottom