Recent content by stavrinaDeve

thank you it was the ground of the encoder ! :-) everything works fine ! Thank you again !

thank you !!!! :-)

yes I have a scope. So what can I do in case there is actually EMI?

AC servo motor . two channels A and B and there is one more that sends a pulse when there is a full rotation i think. " Likely one or both is switching due to the motor oscillating at each step"---> the motor is not moving when i receive these signals . So you say that when enabling the shaft...

hello there ! I have kinco's motors and i am trying to read the signal of the encoders with an arduino . I searched a lot and I wrote a program that can do that, but the problem is kind unexpected.The motor drivers have a digital input so that you can enable the shaft.When i give power to the...

Thank you !

this is why I am asking especially about kinco motors because i think i can't have that option .... thank you

hello everyone ! i have kinco's motors ( if anyone has already worked with one of these it will be very helpfull ) and i try to apply torque control giving signals through a PLC. My control system is like this http://arvc.umh.es/parola/lesson1_archives/five_r.png , where in points A1 ,A2 i have...