Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Stephen68

  1. Stephen68

    Hello, new of the forum, thanks for

    Oh, and yes, sorry, external pressure (vacum) is 0.25kPa, but I added DL, S and Lr (so it comes to 0.78+1+0.4*0.25 (S is 0.5, so less than Lr).
  2. Stephen68

    Hello, new of the forum, thanks for

    Stephen, thanks. I cannot increase slope I am already at 18 deg against specified 9deg which I had to fight for. Customer wont allow it. Minimum top angle to reach 4,000mm2 is 150x150x15, which, to me, looks stupid attached to an 8mm shell. I can try and change detail type, but I have a rigid...
  3. Stephen68

    Hello, new of the forum, thanks for

    Hello, new of the forum, thanks for having me. I am designing a 10m Diameter tank, 10.2 high. I am a bit stuck on the roof-to-shell joint. The last course is 8mm and I have chosen the minimum top angle profile (75x75x8). Now, here's my problem: when I calculate the minimum participating...
See more

Part and Inventory Search

Back
Top Bottom