Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by StephenMF

  1. StephenMF

    Pressure Vessel: Yoke design

    Thank you TGS4, I would be very grateful if you could provide me some references.
  2. StephenMF

    Pressure Vessel: Yoke design

    Thank you for your response TGS4, I have found a brief quote KD-6 in VIII-3, however, I would like to know what rules of the division could be referred or applied to this quote.
  3. StephenMF

    Pressure Vessel: Yoke design

    Thanks for the response, I have checked the Section VIII, Division 3 and I have only found about wire-wound Yokes. However, I have not found rules for other types of Yokes.
  4. StephenMF

    Pressure Vessel: Yoke design

    Hello everyone. This is a new area for me and I have a basic question about the pressure vessel code. I am developing a project in pressure vessels according to Section VIII, however I have not found any information about Yokes or frames, which standard has to follow? Thank you for your kind...
See more

Part and Inventory Search

Back
Top Bottom