Recent content by SuperCat

For orifice, why is it not enough to just use P/T compensation embedded in flow comp? At which point do I need to adjust URV or resize the orifice bore?

Thanks for your reply, if it is an orifice, did I need to change the orifice sizing or can I only compensate the error with P and T transmitter?

I've installed vortex flowmeter for steam flow with initial design of superheated 45kg/cm2 and 400c temp. However, the temp now dropped to 240 and pressure 37kg/cm2. I checked now that the steam is bo longer superheated, how should i adjust the setting in flowmeter? because the density is now...