Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by suren12564

  1. suren12564

    STEAM TURBINE MODELLING BY USING CEASAR II

    Greetings to everyone. At present, I am evaluating Steam turbine piping loads as per NEMA S23. The analysis is being done by using CEASAR II Software. I do not have past experience in dealing with steam turbines. I am seeking guidance from the subject experts regarding how to model the steam...
  2. suren12564

    Greetings to everyone. At present,

    Greetings to everyone. At present, I am evaluating Steam turbine piping loads as per NEMA S23. The analysis is being done by using CEASAR II Software. I do not have past experience in dealing with steam turbines. I am seeking guidance from the subject experts regarding how to model the steam...
  3. suren12564

    Why we are limiting variability of

    That is what I couldn't imagine and seeking explanation. How does it effect the piping system??
  4. suren12564

    Why we are limiting variability of

    Why we are limiting variability of spring with in 25 percent. How does it affect if I choose a variable spring with variability exceeding 25 percent. Thanks in advance
  5. suren12564

    Volume Bottle type pulsation dampener and calibration pot sizing

    For one of our new project we have tp put Calibration Pot at the pump( mechanical operated diaphragm pupms) suction and Pulsation dampener( volume type pulsation dampener) at the discharge. Could any one please gude me for sizing the Calibration Pot and Pulsation dampener to suit below...
  6. suren12564

    stress in pipe

    thank u so much guys for clarifying my confusion
  7. suren12564

    LONG RADIUS BEND TECHNICAL SPECIFICATION

    Does any one have technical specification of long radius bends(made of carbon steel/alloy steel/stainless steel) which covers all inspection/design requirements? thanks in advance
  8. suren12564

    stress in pipe

    i want to differentiate it with respect to magnitude not w.r.t direction?
  9. suren12564

    stress in pipe

    what is the difference between axial stress and longitudinal stress in a pipe under internal pressure? i am always having little confuse between these two....eloborate explanation is appreciable
  10. suren12564

    chlorine di oxide transportation

    can chlorine di oxide transported through carbon steel pipe?
  11. suren12564

    straight run for orifice flow meter

    if we won't provide the suffice horrizantal run up stream to the orifice flow meter ( considering fluid is passed through bends and fittings up stream to orifice) the flow profile would get distorted and flow element won't show accurate results.But how come flow profile down stream to the...
  12. suren12564

    straight run for orifice flow meter

    why in down stream to the orifice also straight run is required? thanks in advance
  13. suren12564

    SEAM PIPE

    thanks for your views guys
  14. suren12564

    SEAM PIPE

    Why circumferential seam is not allowed in manfacturing of welded pipes?
  15. suren12564

    h202 service

    thanks a lot guys for sahring valuable information

Part and Inventory Search