All i am sorry, I gave the wrong flow rate. I attempted to simplify the question that i was asking and accidentally used the total flow of the system. The majority of the total flow 47 in^3/sec is bypassing the section that i am concerned about.
The actual flow rate at the inlet orifice is...
1. It is a fixed volume.
2. P2 is a static pressure but is being influenced by the dynamic pressure at the start of the micro branches. (i think they are acting like pitot tubes). The whole system is filled with fluid.
3. There is no flow in the microbranches
4. I think the flow path has a lot...
So my question is in relation to fluid flow and pressure. In my pictures below you can see that i have two similar situations. Fluid flows in from a large reservoir at a constant rate through a control orifice. It follows the red arrow and flows around a 90 degree angle into a tube. Up to this...
