"Ansys allows to calculate stresses when I'm using harmonic response?"
No. The program is just finding eigenvalues and eigenmodes, there is no displacement or load considered, thus no stress outputs.
Sorry I disagree with you. On harmonic response I can considered forces... I think you are...
Hello everybody.
I'm trying to simulate a harmonic response on a structure with beam element. I have results for deformations but when I try obtain the equivalent stress (Von Mises) the program give a green check but on "geometry" doesn't show anything (except the structure), in fact program...
Davemechuck when you say in another way I can create connections constraints in Mechanical in this case I can't create a multi-body part in design modeler correct? Only transfer the line bodies to Mechanical and add the connections have I right? Another question: The best way to meshing beams...
Thank you a lot Davemechuck. You help very much!
I understand what you mean but at this momemnt I'm working in the same structure but in this case is a 3D model instead 2D. I proceed the same way (create points and beams) and in the final I create a multi-body part with all beams but ANSYS...
Hello Hurricanes.
Where's the option "join" in designmodeler? I have ansys workbench 14.5 and I tried locate this option in help and I only found "joint".
In another way I was able to solve my first question... in design modeler I make a new part from every line body... this solution works...
Hi everyone!
I started a few days working with ansys, now I try to analyse a structure with many beams. I used the designmodeler to construte my model (I use points, lines and cross sections). When I use only 1 line with a few points and only 1 cross section I can obtain results, but when I...
