I am working as a mechanical design engineer but I don't remember doing these calcs. The dual output shafts from the gear box are in the middle of the assembly with two piston/cylinders on each side. The pressure in the cylinders should be 2200 psi but we ran them at 1500 psi. This setup is...
I am trying to to Dynamic load cals on deep groove radial bearings. the set-up consists of 4 piston/cylinders hooked up to motor and gear box. Using a crank, two piston are moved to one direction and the two on the other side are moved in the opposite direction. We ran the system at 1500 psi...
I am trying to do a dynamic load calculation on a system. I have 4 cylinder/pistons connected to motor and gear box. There are 8 bearings used on the middle shaft and a crank is used to move 2 pistons on one side and then to the other. We ran the setup at 1500 psi system pressure and the...
