Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by uwpioneer

  1. uwpioneer

    PTC Creo- "Unfolding" sheetmetal (Picture included)

    Hello all, I have recently designed this solid part and have converted in to a sheet metal part in Creo Parametric 3.0. However, I need to "unfold" this cylinder-like part and locate the "rip" at one of the flat sections. I can get a flat section if I unfold it where one of the "rolls"...
See more

Part and Inventory Search

Back
Top Bottom