Vrpeng-tips's latest activity

Any feedback would be appreciated. Thank you in advance.

OK. did some more reading and I think I have little more clarity. So, FEA can be used under U-2(g)(1)(-c) to design component thickness...

I say the method is not valid because Div.2 part 5 is not being used. 1. Not checking all modes of failure. 2. The stress limits are not...

Thank you IdanPV and TGS4. thank you for pointing out UHX-1(7)(b), my bad I didn’t read that far. So I am left with, Option one =...

IdanPV, I really appreciate your reply. It actually made me RE-READ the code. I also read your other post...

Not sure if I am being clear or not. Let me rephrase my questions & background. fixed tubesheet heat exchanger, config. b, tubesheets...

Hi IdanPV, Thank you for your response. Yes, the rules for HX have moved to div.2 part 4. Which is design by rule method and shall be...

Hi TGS4, Thank you for your response. For Div.1 ed.2023 fixed tubesheet heat exchanger, all components are designed using Div.1...

Hello Experts, Any insight on this would be greatly appreciated. Thank you.

correction. For a fixed tube sheet div.2 part 4.18 applies. And design can be completed using DBR.

Hello, Unit - Div.1 U-Stamp heat exchanger Most of the design of the unit can be done using div.1 rules (Shell, Nozzles, head,etc..)...