Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can bend beam Rebars 90 deg vertically inside lift wall instead of straight towards wall?

LewisLiew

LewisLiew

Civil/Environmental
Apr 14, 2015
20
I am inspector of work.

Would like to know whether bottom or top rebars for 1st floor beam CIS B 4T32 to bend 90 deg to top/bottom at approximately 300mm (Drawing shown straight 1200mm inside lift wall & 800mm each). I am asking because contractor will put foam at lift wall 300mm so later can cast beam.

FunPic_20250221_234015267.jpg
 
Last edited:
Replies continue below

Recommended for you

Sort by date Sort by votes
CIS B beam width 400 mm while core wall thk. 300 mm. What is your plan for installing 4T32 bars in the wall ? Can you post the perspective if you have studied ?

Top and bottom 4T32 bars implies the beam is coupling beam and the structure at seismic region.
IMO, the development length for top and bottom should be same.
If the contractor planning to put foam at lift wall and cast beam later , i would prefer to use coupler .
 
Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

psychedomination
  • Question
Retaining Wall on Basement Wall
Replies
3
Views
3K
CJLCivilStruct
CJLCivilStruct
StrEng007
  • Question
Masonry shear wall on transfer beam
Replies
1
Views
2K
KootK
KootK
ITsSB
  • Question
Thickness of seismic RC Wall 1
Replies
5
Views
3K
HTURKAK
HTURKAK
Brobocop
  • Question
Coped Wide Flange Beam at Exterior Wall
Replies
8
Views
3K
KootK
KootK
Brobocop
  • Question
Steel Beam to residential exterior wall connection
Replies
10
Views
6K
XR250
XR250

Part and Inventory Search

Sponsor

Back
Top Bottom