rothers (Mechanical)28 May 19 11:21
What's the existing drawing specification (Dia & Tol) for the flywheel hole ?
I'm not sure, I have no access to the original drawings, I'd estimate they've been speced at 1.6mm +-0.01 by feel of the fit.
Jboggs (Mechanical)28 May 19 12:00
If you end up...
Thanks rb1957,
Yeah, the wheels are being glued in house, I suggested sending them to the vendor, but it seems that isn't an option. I'm not sure how they're pulling them off, I've mentioned that any kind of pulling is a bad idea and highly likely to damage the motor bearings unless they have a...
x-post from Aerospace
I'm helping out with a little bit of design work at a small aerospace company, they've just lost there full time Mechanical engineer and are having a number of issues with some parts turning up. One of these parts are brass flywheels for an inertia wheel model.
The...
I'm helping out with a little bit of design work at a small aerospace company, they've just lost there full time Mechanical engineer and are having a number of issues with some parts turning up. One of these parts are brass flywheels for an inertia wheel model.
The motors that are being used...
