Good morning,
I would like to apply a bending moment to a beam modelled with solid elements. However, solid elements have only ux, uy and uz DOFs.
Actually, I’m interested in the stress stae caused by the bending moment and I have also tried to apply it to each node using the “sf” command...
Dear BAretired,
thank you a lot for your answer. I am so sorry for being rude. It was not my intention, I don’t check the forum often. I am so sorry for that.
Your edit helped me a lot. I think this is the correct way to proceed.
Thank you again for your time and help.
Chi
Hello,
I hope there is someone who can help me with the problem I am trying to solve. I have a structure composed of a beam, located at the centre and connected to two plates. Each plate is supported by a torsional spring. Since the stiffness of the plate is higher than the one of the beam, the...
Hello all,
I'm doing a simple static analysis of a structure with electromechanical coupling and I'm using ANSYS APDL. The problem is that, ONLY when I apply a force with an higher value, I obtain this error:
*** WARNING *** CP = 36.984 TIME= 17:18:55
There is not enough memory for...
Hi everyone!
I have a doubt and I hope there is someone who can give me an advice.
I am modeling a MEMS gyroscope for my Master thesis and I am starting with a very basic structural design. My gyroscope is composed by a central mass suspended by for beams. Since the central mass thickness is...
