Search results for query: *

This link describes it: https://www.youtube.com/watch?v=dLPa3TOW-20

Dear All, I am trying to excite a piezo and apply acoustic wave pressures to a laminar flow which has a solid particle in it. As a result I want to see how the wave move the particle in the flow. Here is an experiment that demonstrates mainly. https://www.youtube.com/watch?v=PinJemkfiV8 I...

Dear All, First of all thank you very much for your helpful suggestions. I try to answer your questions. I also attached the images that show how the lines are connected to the table and how the tubing connected to the ceiling. At my side we are now giving the order for flexible hoses to put...

Dear All, I have a vacuum chamber set up in my lab sitting on the vibration isolation table. There are gas lines coming from the ceiling and connected to the chamber. Stainless steel 1/4" gas lines are clamped to the ceiling, but that connection conducts the vibration from the ceiling to my...

The properties are temperature dependent but they were checked.

All units are already checked. And nodes are well located. Any other opinion? Thanks

I am runnin simulations for heat transfer analysis counting conduction, when I add the effect of surface radiation to environment with *radiate or *sradiate , I am getting the error message: ***WARNING: Temperature at 1 nodes has fallen below absolute zero. Increment will be...

Dear Abaqus Users; I meshed my 3d simple rectangular part as an unstructured mesh. As you know the partition option is available in cae mode. But I used input file to generate. While doing this I defined the two different pair of nodes at the middle section so I meshed top part refined and...

Can anyone familiar with Abaqus animations? I have a multistep simulation and in each step I want to show different elements and then get the movie of this. For example lets say I have 1:100 elements: at first step I just want to see 1:50 elements at second step 1:51 elements third 1:52 and...

Thanks for your reply mrgoldthorpe but I want to model without removing just adding the elements. Is there a way to do this? And it is not CAE supported command so how can I get video of this simulation? Thanks

Hi; I am trying to simulate material deposition to substrate. In our case material is added to substrate and there is a distributed heat flux with constant velocity acting by node by node. I want to simulate showing the added material in the simulation and its effects. There is a command for...