Hey Cnc and Capnhook,
I am indeed doing some incremental forming, and although I think your solution would work I am hopefully going to move on from simple cone shapes into more asymmetric geometries in the near future. So far I've had success with the -10% starting point in the streamline...
Hey Mark,
I see what you're saying, and I do get the cyan lines, but I am trying to (in general) eliminate them entirely. I am actually not milling, I'm doing some incremental sheet forming, but using NX to do this type of contour milling which will give me the toolpath I need for the ISF...
So a bit of an update. As you all suggested, using the starting point as -10% did move the toolpath up to the surface and seems to take care of the issue I had in my first question.
However, the toolpath with the streamline is still roughly 2500 lines (which is 500 more than our CNC controller...
Hey Mario and Mark,
Thank you both for the suggestions! I'll give them a shot in just about an hour and report back what I'm able to do based on your input.
Could I clarify something though with the spiral generation (essentially my 2nd question)? Although I cannot use arcs to simplify the...
Good afternoon all,
I'm learning a bit more about the streamline drive for contour milling, and have a question about why my first pass is penetrating the part so much. I'm working on making a toolpath for an incremental forming operation, and to do so I have created a geometry which is the...
Ah hah! I think I'm finally understanding the suggestion. I had given it a shot, but I thought the steps were still too big, but upon reading Chig's suggestion I think I understand now.
I'm working in excel now to parse the information and get the coordinates in a more ordered list, but I am...
Thanks for the response! But I think what I'm looking for is a bit different from what you explained.
When I post process the toolpath I see that it gives me "some" X-Y coordinates, but I am looking for a way to see the coordinates of the tool (say the center of the tool tip) at all points in...
Good afternoon folks,
I was wondering if anyone had a suggestion as to how I could extract the X-Y coordinates of the cutter throughout a toolpath that I created within NX 9's manufacturing module. My issue is that I want to import this toolpath into ABAQUS FEA software, but the way that I...
