It’s not stated, but you can’t reasonably enforce the draft angle of that drill tip at the base of the wider cylinder.
Is there any known convention that general surface profile has an application limited to surfaces that are not holes?
The note would go something like this:
“This is a minimal dimension drawing. The CAD model is the master for all dimensions not shown on the drawing. Part profile 0.025 A B C unless otherwise stated”
I’ve also attached an example of one of the points in question.
I have a quandary that appears quite often on prints I work with.
A given part has a general profile to govern undimensioned features. On said part I have a blind, threaded hole called out on the print to Y14.6 standards. There is a section view of this hole with a cylinder depth called out...
