Search results for query: *

Hi folks, I swear I had notifications on, but I received none. The vessel is a lyophilizer, in stainless. Its a commercially purchased vessel, and I believe the nozzles are reduced to match the BPE piping that attach to the vessel. I have an entry knowledge into ASME VIII, so I'm thinking the...

Have a question as the title says, I have a vessel where the nozzle is a machined 1.5" XXH pipe. The pipe is tapered at the end from .265" to 0.063", where a flange is added and another pipe bolted to it. So, my question is, which portion is the code dependant portion, the 0.265" which is 2.7"...

Thanks

I see a bunch of posts that Code Case 2260 was being annulled, but can not find an answer if it has been or not. I'm looking at re-rating a vessel built in 2017 that used both 2260 and 2695... And looking to see if the original design is even valid. Thanks

Thanks. That's what I thought. New to all this so had to double check. Thanks again

Question for folks. Is there any time that a 1.5" nozzle, not an inspection opening, is exempt from the minimum thickness of UG-16, 0.0625" ? Thanks

I have a question on API 581 Annex 3. Determining the representative fluids of a stream. My uncertainty comes when the stream contains none for the streams listed in Table 3.A.3.1, my stream is elemental Sulphur from a Condenser. I am unsure on how to deal with this, as Table 3.A.1.1 is...

Hello, I'm doing a run of simulations which has 1 or 2 loads changed. I'm plotting a path and graphing it. My issue is every time I run a new simulation, I need to redefine my paths each run. My question is, Is it possible to set the paths so as to keep them defined every sim? I've seen...