Hello, I had the project a little stopped and now I`d like to put it back to live. Sorry for delay.
Mechanicadesingns, I`m using Labview software.
Gruntguru, can you give a aproach of how you will make the calculation? the power is normally measured at the flywheel so internal inertia should...
Thank you very much Lionelhutz, dN rad/sec and dt is in seconds, right?
On here, P = (inertia x N2^2/2 - inertia x N1^2/2) / dt
What is ^?
Thank you very much tbuelna for the input, where can I see some information on this DC dyno? I already are working on edd current basis but I can test on...
I`m fighting with pid calibration and think about the possibility to calculate the power/torque from the acceleration rate.
Steady with a constant torque reading is hard to get in a short time so if I want to get a lot of points it take time, I have to figure out a lot yet.
I have to calculate...
I would like to calculate power without setting steady state, so if I have inertia and braked torque and rotational speed or aceleration, can I calculate power correctly?
Hello I`m working on a braked dyno build, I`m using 2 eddy current brakes with load-cells and a NI DAQ.
I`m getting a bit of mess with the software.
Is possible to calculate the power output, knowing the braked torque and the acceleration rate?
Regards
