Search results for query: *

We supplied SA 516 GR 485 with 316 Clad quenched and tempered plates. When reviewed the MTC, tension test applied only one sample for each plate but two tension test coupons shall be taken from each quenched and tempered plate as heat treated according to SA-20. Could you please explain number...

We supplied SA 516 GR 485 with 316 Clad quenched and tempered plates. When reviewed the MTC, tension test applied only one sample for each plate but two tension test coupons shall be taken from each quenched and tempered plate , as heat treated according to SA-20. Could you please explain number...

Good day to all, Is it possible to SS plate weld over SS weld overlay or clad surface after PWHT as per ASME SecVIII Div1 Ed. 2019 or prohibited? and where is reference in code sections? Regards.

Good day to all, What is the weld seam/bead width tolerance for as welded longitudinal and circumferential joints according to AWS D1.1? Thanks in advance

Good day to all, What is the weld seam/bead width tolerance for as welded longitudinal and circumferential joints according to ASME SecVIII Div1/SecIX/AWS D1.1? Thanks in advance

Hi, What is elliptical formed head depth tolerance according to ASME SecVIII Dİv1 and where is indicate? Best Regards.

Hi, I'm confused about acceptence criteria for forming elliptical head. We prepared a control template from inside for ID 4700 diameter. Due to UG-81 we must measure knuckle radius so what is tolerance for gap with use control template? 1.25 x ID 4700 or 0.625 x ID 4700 which one? "The inner...

Good day to all. The difference between the maximum and minimum inside diameters at any cross section shall not exceed 1% of the nominal diameter at the cross section under consideration as per ASME Section VIII Div1 so that’s meaning is ovality. I wonder what is the tolerance for inside...

Correct, I mean raised face. Thanks for quick reply. Regards.

What is the tolerance for inside and outside diameter of machining spiral wound gasket surface due to ASME B16.5 (For 6” nozzle). I saw exact measurements without tolerance regarding standard. Thanks.

Thanks for reply. Para 13.2 is clear for understanding regarding manufacturer plate markings.

Is hard stamp for shell plates mandatory according to ASME SecVII Dİv1? Which code number/paragraph defines depth etc details regarding hard stamp?

Hi, What is the weld seam width tolerance for as welded longitudinal and circumferential joints according to ASME SecVIII Div1.

Hello all, Unless otherwise specified, ASME nameplate must be show UT, W, RT1 and HT for full radiography due to ASME SecVIII Div1 Ed 2019. Is this right?