Search results for query: *

Yes. I have got the building permit for this.

Hi Jayrod12, 1) I will cut the sliding where I need to put ledger. 2) Put vinyl thin sheet tuck up side into existing sliding. 3) Put weather proof sealant top of the board. 4) put Vinyl Window and door cap on top 5) Once leg bolts are in place put sealant around them as well. Thanks,

Hi Everyone, THANK you so much for the help and precious input. Hi Pete600, THank you specially. Just one last thing, Does the fitting works fine with Anchor and Side braces in above link?

Hi Pete600, Lateral load: If I connect the entire structure with ledger board should that be enough to handle lateral load? House external wall is on both side of this structure. I can connect this structure with ledger board to house on back and on one side as well.

So in that case, I can do one thing. 1) Connect the post to concrete with : http://diy.stackexchange.com/questions/44028/how-wide-does-a-6x6-concrete-post-footing-needs-to-be on the one of the hole of this post base I connect following on both side...

This is how the plan says...

For the horizontal forces 1) diagonal bracing to beams 2) bracing the post to beams Do you think this would enough? If not, I could put the ledger board for second floor.

Thanks for valuable suggestion. Any technical suggestion/solution? I would have done if possible.

Folks, I have started building two story deck with dimension total - 36x10'8" level 1(18" below level 2) 19x10' 8" level 2 17'x10'8" Following are limitations. 1) I have a grading way from home there is difference of 4-5 feet between highest and lowest point of deck. 2) I have created 12...