Hello all
I have a rotary stage design that was intended as a "simple and cost effective" solution to orient mirrors for a high precision opto-mecanical application. I produced several of these units for using horizontally (output axis is vertical). Now we have to extend its usage to vertical...
I am looking for a supplier for a polyurethane belt coated on the outside with rubber or friction polymer. Low RPM, belt must also be machined in the center (holes and teeth emoval in the center section) for suction devices integration.
The belt is 2 inches wide, overall thickness 1/4 inch...
I have a wheel drive design for an off-road vehicle that uses a 155mm double-lip seal in contact with anodized aluminium. I want to reduce friction on this surface to minimize wear and reduce energy consumption during operation.
The aluminium part is a fully machined part 6061-T6 so it cannot...
