Dear Experts,
I would like to obtain the minimum thickness of the standard flange for in-service equipment or piping where undergone crevice corrosion resulting in wall loss on the flange thickness.
With regards to the minimum thickness of the standard flange in accordance with ASME 16.5...
Dear All,
Could anyone advise me the Calculation of SAFETY DISTANCE for pressure testing;
Based on my knowledge the following Code covers the equation;
a) ASME PCC 2 Article 5.1, Mandatory Appendix III - Pneumatic safe distance
b) Lloyd's register (96-02) T-0240 - Hydrostatic and Pneumatic...
Dear marty007,
Highly appreciate your explanation and it's really thoughtful for better understanding.
With regards to a maximum pressure of the bends, I understood the formula to calculate as in below;
((2*t*S*Ej*W/I)/(OD-2*t*Y))*6.894757 = XXXX KPA
Question: The I should be?
where at the...
Thank you for highlighting and just realised the unit mixed up.
I have corrected according to as in below;
I = [4(R1/D)-1]/[4(R1/D)-2] @ Example : I = [4(3/2.37)-1]/[4(3/2.37)-2] @ ANSWER is 1.32
and at the extrados (outside the bend radius):
I = [4(R1/D)+1]/[4(R1/D)+2] @ Example : I =...
Dear All,
I need your assistance on the minimum thickness and MAWP calculation for pipe bends based on ASME B31.3 clause 304.2.1;
The minimum required thickness of a bend after bending in its finished form is calculated by:
t-min = (PD)/2[(SEW/I)+PY]
where at the intrados (inside bend...
