Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. PVLead

    UG-36 in ASME Sec VIII, Div I 1968 Edition

    Thank you. Does it have a minimum size for stiffening ring attachment welds? Could you perhaps send a screen shot of UG-30? It would be most helpful.
  2. PVLead

    UG-36 in ASME Sec VIII, Div I 1968 Edition

    I need typing lessons. I meant UG-30. Specifically UG-30(f). What does it state?
  3. PVLead

    UG-36 in ASME Sec VIII, Div I 1968 Edition

    I am looking for some information on contents of UG-36 in the 1968 Edition. My library only goes back to 2011. Can anyone help?
  4. PVLead

    ASME Sec VIII Dic 2 Table 4.4.1

    Then the path forward is to go to Part 5 Design by Analysis which allows the material in question up to 900°F.
  5. PVLead

    ASME Sec VIII Dic 2 Table 4.4.1

    There will be on the leeward side doing the wind analysis. Also in seismic analysis. These conditions never govern, always governing is internal pressure at design temperature.
  6. PVLead

    ASME Sec VIII Dic 2 Table 4.4.1

    If a vessel has a Design Temperature of 850°F for internal pressure and 350°F for external pressure, does Table 4.4.1 of Div 2 prohibit the use of low alloy material as material of construction for this pressure vessel? The material in consideration has allowable stresses up to 1000°F in Section...

Part and Inventory Search

Back
Top Bottom