Dear All,
I'm searching for laboratory that can do failure analysis in Malaysia. Below are some of the company listed;
Metacos
Nusatek
Exova
Norimax
Is there any other company that I missed? If you have any kind of information hope you can share the details in here.
Thank you
Dear All,
Based on the standards, it is recommended to design jacket with drain holes for insulated piping system. But i'm not sure if this is already been implemented or not as I have never been to a plant before and don't have any experience in inspection.
So is there someone out there has...
Ohh, I don't know the difference between two. Ok I now I know where to start searching.
Thank you everyone for the valuable information. I really appreciate it
Ok, I think I understand now. Ferrite testing is important especially in weldment area is that correct? Do you guys know what standard to refer if that's the correct FN number for DSS?
If let say, I conducted PMI on certain pipe and it says it is DSS, and then I conduct ferrite testing on the same pipe? Is it reasonable to conduct the same test on the same pipe?
Thank you for reply Metengr
Hi everyone,
What is the purpose of conducting Ferrite Testing if we already conduct PMI? I know Ferrite Testing is used to measured the ferrite in the material and it based on FN, but I thought PMI will also display the Fe composition. Why we cannot use the PMI data to analyse the appropriate...
