AnnaWood,
This is going to be a total Newbie question, but for your Sketch 5, you created a sketch plane that was offset from the center top plane without it being a 3d sketch. This enables you to use the partial parabola function (which doesn't seem to work for 3d sketches).
I can not figure...
AnnaWood,
Wow, thanks. The file you used was at the wrong width (see my second post), however, when I resized it to correct width (in half), it still WORKED!. I am not all that familiar with the tools you used, but I'm spending the day studying your sample and learning it!
Thanks again...
IanLougheed,
Seriously thanks for the quick response and help. I did try the chamfer as well, but again was unable to get the full angle without an error. After looking at your drawing, I realized that (after a really long day), I made a mistake in my sample drawing (although correct in my...
sw2009. Trying to put a 30 degree (each edge -- 60 degree edge total)rounded (partial parabola) on the tip of blade (0.5625" wide, 0.125" thick -- at tip) with a partial parabola of 1".
How do I accomplish this without errors? Sweeping 1/2 profile gives overlap errors because partial...
