I'm looking for how to connect a LP-20 (reversed) waterproof connector to the wires in its cable.
I'm supposed to attach four of the wires in a five wired cable. The five wired cable have a CEE 400 V / 16 Amp connector, and in the other and I need to attach the LP-20.
The LP-20 have its four...
I need a 400V 16A CEE power outlet that is somewhat mobile, at least I should be able to change its location when disconnected from power. I do have the proper CEE extension cable with 2,5 mm2 cables, but the house outlet have an antique fuse box, and no RCD as far as I can see.
I find many...
Hi!
Thank you, that linked locking washer was interesting, it shows a symmetric layout!
The shaft is not in a motor, I use it in a hand driven mechanism and the lock washer is supposed to hold the pinion in a hypoid gear, in one axial direction (the gear wants to push it outwards).
The...
Would like to ask if anyone has seen shaft lock washers (which do not require processing on the shaft like a groove ring) and which could work on a shaft with a flat side?, like a motor shaft that is.
Looking for one to use on a 5 mm shaft, where the need for locking force axially is small, <...
If you want to use low pressure I thank you just can heat the mould to a temperature were you material have low viscosity, basically the same as at the ingot.
To use that method without an extensive heating and cooling arrangement, you will have to accept long cycle times.
