Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. chrizofer

    lofted cone

    Thanks for your replies. I find now though that in order to get the mates I need, I need to generate a revolved section to set the angle at precisely 28.09 degrees. The lofted sheet is much more difficult to get this angle. So I have the full cone and I perform an extruded cut through both...
  2. chrizofer

    lofted cone

    being new to SolidWorks I think my problem is very minor but I thought I'd post it here. Have tried both a revolve and a loft with no success in creating a cone and then the flat pattern for it. I create an arc on a plane. Then I create a plane the distance away from the first plane the...
  3. chrizofer

    adiabatic index of air in receiver tank sizing

    I have a question for katmar based on a response to a question on air receiver sizing. The below response was in response to a sizing question and I have an acquaintance that is referencing an adiabatic index of air which I did not see in your response. Can you or anyone tell me why or why not...
Back
Top