Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
2 Single Segment FCF to make Rectangular Tolerance Zone?
I was just looking through the book again and found Fig5-41 on page 139. So it's clear that the top example is both by the book and clear. And the bottom example is just incorrect. Thanks all!- JasonSp
- Post #6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
2 Single Segment FCF to make Rectangular Tolerance Zone?
I have seen a number of drawings where a hole ends up with a larger tolerance east-west than north-south, so rather than expand the diametrical tolerance to cover both, I see two reference linear dimensions with separate control frames. (See top example) I was wondering if possible to combine...- JasonSp
- Thread
- Replies: 53
- Forum: Drafting Standards, GD&T & Tolerance Analysis
