Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. mithuntech

    Dents

    References For pipelines under ASME B31.4, Clause 434.5. For pipelines under ASME B31.8, Clause 841.2.4(c). Query Both the referred clauses specifies dent as a percentage of nominal pipe diameterfor pipe diameter greater than 12". Please could you confirm whether it is referring to nominal...
  2. mithuntech

    Pigging for slug removal

    Thank you all for the responses. @LittleInch By "sphere pigs", i meant spheres. @pennpiper No. I meant different pipelines of sizes 12" and 16". Not dual diameter pigging as you mentioned.
  3. mithuntech

    Pigging for slug removal

    Wet gas field development project requires the transfer pipelines 12" to 16" sizes to be designed for slug removal by pigging. The frequency of pigging is not available at this stage of the project. These pipelines also needs to be designed for intelligent pigging. Please share your views on...
  4. mithuntech

    Code ASME B31.4 - D/t ratio less than 20

    Clause 402.3 Stress From Internal Pressure For both restrained and unrestrained pipelines, the circumferential (hoop) stress due to internal pressure is calculated as (U.S. Customary Units) SH =PiD/2t The above equation may not be applicable for pipe D/t less than 20. Is there any reference or...
Back
Top