Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. wmdnbs

    Need help find specs for a gasket/seal

    Thanks Ted. I will be contacting them this morning. I believe you are correct. Bob Stratz Solids Designer
  2. wmdnbs

    Need help find specs for a gasket/seal

    Can anyone help me find the specs for the following gasket or seal? TEC-ring J-430-7-R-T TEC-ring J-449-7-R-T These numbers show up in the BOM for an extruder screw we are rebuilding, and need to replace these parts. So far we have had no luck searching for them. Bob Stratz Solids Designer
  3. wmdnbs

    Looking for 5 axis CAM system.

    I am currently looking for a 5 axis CAM system. The absolute minimum requirements are: 1.) The ability to perform rotary milling using flat bottom cutters offset from center to avoid work being pushed into the bottom of the cutter. Our work is too large to consider using ball nose for roughing...
Back
Top