Hi all,
Not sure if this is in the right section, apologies if not.
I have been tasked with checking a hydraulic manifold design is adequate and I would like to check the bolts details.
See attached image. The manifold is bolted to a flat face (blue) via three bolts (black) and has two ports...
Hello, thanks for the reply.
tbuelna- Thank you Terry. I have done FEA analysis using Ansys but because the the thin ring is bonded by the edge touching the thick ring/cylinder (without the weld) there are huge stress values where the weld would be. Im not too sure but I think the values aren't...
Hi All, I am trying to work out the stresses in a single lap fillet weld. Looking at formulas for fillet welds there doesn't seem to be any for a cylinder single lap fillet weld. I thought about using the formula for a single lap fillet weld but this is for a flat plate and doesn't account for...
