Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: B89
  • Order by date
  1. B89

    shaft's total run-out changes after being mounted onto the assembly

    I measured the run-out before installation by putting the bearing housings on a flat surface. so you could tell that the shaft is bending, I will examine this as Billpsu said,
  2. B89

    shaft's total run-out changes after being mounted onto the assembly

    hi everybody, it's a shaft supported on bearings both ends. http://files.engineering.com/getfile.aspx?folder=97850565-359d-4edf-9c35-4459e65bc6e7&file=Capture.JPG when tested by dial indicator outside the assembly frame, total run out is within tolerance, i.e. 0.1mm. but when inserted into the...
Back
Top