Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. AndyThody

    Hi all, Is there an easy way of cr

    Hi all, Is there an easy way of creating a (module) gear tooth profile in NX7.5. Thanks for any help. Will help any one out when I get more used to the system. Thanks all.
  2. AndyThody

    Flat patterns

    NX4 was so easy to create flat paterns in sheet metal, what is an easy way to do it in NX7.5. Tanks for any help. Andy.
  3. AndyThody

    NX7.5 text transfer from drg. to drg.

    Rock n Roll. Thanks.
  4. AndyThody

    NX7.5 text transfer from drg. to drg.

    Hi All, Is it possible to transfer a drg note from one drg sheet to another in Nx7.5, as it was in NX4 by simply clicking on the note which it would then remember and allow you to add that same note to a new drg. Thanks, Andy.
  5. AndyThody

    NX 7.5 HOLE POSITIONS

    Hi all, May seem silly to all of you, but what is the best way to position a hole on the end of a round shaft? Not as good as it used to be.
  6. AndyThody

    Broken views

    Hi all, I have a detail of a shaft 2m long. In draughting I have 2 views of the shaft each view has a break in it. Is there an easy way of aligning the views and making both views the same length? Andy.
  7. AndyThody

    system materials

    Hi everybody I have used other systems where you can colour a model to its actual material colour (I am using NX4 which has system materials, brass, copper etc) how do I apply these to models. Thanks for any ones help, Andy.
  8. AndyThody

    Sketch

    Hi would be grateful of any help on this problem. How do I fully constrain an elipse in sketch?.
Back
Top