Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Motorola MOSCAD/Toolbox, radio links?
NoHOCa, You are correct. I the previous posting, I mentioned assumptions. One was that because it was a SCADA system, that the programming had some basic generic properties. Secondly, you are right about the table addressing. The data from the RTU's will correlate to a table, row, and...- SCADABOY
- Post #7
- Forum: Programmable logic controllers (PLC)
-
Motorola MOSCAD/Toolbox, radio links?
Unfortunately, I am not familiar with Maple software. However, I have to make a few basic assumptions. Fully aware of assume=ass out of u and me. Our system uses Intellution software (which should be similar) along with the Modbus interface to process our alarms and data. Our analyst asks us...- SCADABOY
- Post #5
- Forum: Programmable logic controllers (PLC)
-
Motorola MOSCAD/Toolbox, radio links?
You have the same capability with the 9.5 and 9.54 toolbox software packages. Use your MDLC configurator to vary your link settings to match what you are presently using. If you don't and start using the higher versions of toolbox, your links will be incorrectly displayed when you go to...- SCADABOY
- Post #3
- Forum: Programmable logic controllers (PLC)
-
Motorola MOSCAD/Toolbox, radio links?
You have the same capability with the 9.5 and 9.54 toolbox software packages. Use your MDLC configurator to vary your link settings to match what you are presently using. If you don't and start using the higher versions of toolbox, your links will be incorrectly displayed when you go to...- SCADABOY
- Post #2
- Forum: Programmable logic controllers (PLC)
