Hi,
Fluids I am considering is air (at around 100 C at entrance). In the case I am considering holes on inner cylinder's curved surface are blocked, since material to be dried covers much of the curved surface (especially during high RPM). So I am assuming that flow will occur mostly through...
Hi,
No, this is not for school. I posted the same question but accidentally put it in wrong forum. I reported that question and asked if could e routed to this forum. I got reply that I should just repost it in this forum. After that question posted on earlier forum was gone. And it is here...
Hi,
I originally asked this question. Yes, it is Dryer. I am trying to make Math model of it. Model consists of each physical component of machine. Each component is physical representation of momentum, energy, mass transports happening inside of it. But as opposed to CFD, here it is considered...
Hi,
(I am a first time poster. If in your experience this question suits more to other forums please suggest me that)
I would to like to ask my question in series of increasingly complex scenarios.
1. A hollow cylinder (diameter/length = 1.585 and diameter = 0.5 m) with holes in its rear...
